
Putting Your Boat Up for Winter: A Four States Storage Checklist
Pull into any boat ramp parking lot at Grand Lake, Table Rock, or Stockton on a late-October Saturday and you'll see trucks and trailers lined up. Some folks are squeezing in one more crappie trip. Others are pulling the boat for the year. Either way, the season around the Four States is winding down, and what you do before your boat sits for the winter decides a lot about how it starts next spring. A boat that's put up right usually fires up in April with no fuss. One that's parked with old fuel and water in the lower unit can turn into a repair bill. Here's a plain, practical checklist.
Start With Your Owner's Manual
Every outboard, sterndrive, and inboard is a little different, and the manufacturer's storage steps come first. Some engines call for fogging, some have their own storage mode, and some list specific flushing steps. Use this post as a reminder list, and let your manual have the final word.
Treat the Fuel and Run It Through
Fuel that sits all winter can go stale, and today's gasoline, especially ethanol blends, can absorb moisture. That's a real concern in a boat tank that breathes humid lake air.
- Add a fuel stabilizer to the tank, following the treat rate on the bottle.
- Run the engine long enough afterward to get treated fuel through the fuel lines and into the carburetor or injectors. Stabilizer only protects the fuel it actually reaches.
- Ask your manual or marina whether to store the tank full or nearly empty for your setup. A full tank leaves less room for condensation, but practices vary by boat and fuel system.
- Check fuel lines, primer bulbs, and the fuel/water separator filter for cracks or water. Winter is a good time to swap a separator filter that's due.
AMSOIL makes AMSOIL Gasoline Stabilizer for fuel that's going to sit, and AMSOIL's product page lays out what it's designed to do and how much to use.
Change the Oil Before Storage, Not After
If your boat has a four-stroke engine, a lot of owners change the oil at the end of the season instead of waiting until spring. Used oil carries moisture and combustion byproducts, and you don't want those sitting in the engine for months. Change the filter while you're at it.
Which oil and how much depends on your exact engine. Rather than guess, look it up in the AMSOIL Marine Outboard Lookup Guide, or use our Vehicle Lookup Guide for other equipment. You can also browse AMSOIL's full marine product lineup, which includes four-stroke marine oils, two-stroke oils, and lower unit gear lube.
Drain and Refill the Lower Unit Gear Lube
This is the one people skip, and it's the one that can cost the most. If water gets past a seal, it settles in the lower unit. Over a Missouri winter that water can freeze, and freezing water can crack a gearcase.
- Drain the gear lube and look at what comes out. Milky or creamy-looking lube can be a sign of water getting in, and that's worth having a marine shop check.
- Look for metal on the drain plug magnet. A little fine paste can be normal; chunks are not.
- Refill with the gear lube your engine maker specifies, filling from the bottom hole until it comes out the top vent, then put in the top plug first. Replace drain plug gaskets if they're worn.
Fog the Engine If Your Manual Calls for It
Fogging oil coats internal engine parts with a protective film to help guard against corrosion while the engine sits. Not every engine calls for it, and some newer fuel-injected outboards have their own procedure, so check your manual first.
AMSOIL says its AMSOIL Engine Fogging Oil is designed to protect internal engine components against rust and dry starts during storage, and lists outboard, sterndrive, and inboard marine engines among its uses. Follow your owner's manual for how to apply it.
Get the Water Out
Freezing water is the big winter risk for any boat engine that's cooled by lake water. Outboards usually drain on their own when they're trimmed all the way down, but inboards and sterndrives often have drain plugs or a specific draining procedure.
- Flush the engine with fresh water if your manual recommends it, then let it drain completely.
- Store an outboard trimmed down so water can drain from the gearcase and powerhead.
- For inboards and sterndrives, follow the manufacturer's draining or antifreeze steps carefully. If you're not sure, this is a good job to hand to a marine shop.
- Don't forget livewells, baitwells, washdown pumps, and any plumbing that holds water.
Grease, Battery, and Trailer
- Grease the fittings on the steering, tilt tube, and swivel bracket per your manual so moisture doesn't settle in. AMSOIL carries greases, including a water-resistant synthetic grease.
- Take the battery out or disconnect it, store it somewhere it won't freeze, and keep it charged with a maintainer.
- Look over the trailer: wheel bearings, tire pressure, lights, and the winch strap. It's a lot easier to fix in November than the morning of your first spring trip.
- Clean the boat, pull the drain plug (and leave yourself a note on the steering wheel to put it back in), and cover it so it can breathe without trapping moisture.
We're Here to Help
Walter and Regina Hayes are your local AMSOIL Dealers right here in Carl Junction, and we're glad to help you find the right oil, gear lube, and storage products for your boat. Request a free AMSOIL catalog, or become an AMSOIL Preferred Customer and save up to 25% off retail prices. Not sure what your engine takes? Call us at 1-417-649-6776. We're always happy to talk shop.
Ready to protect your engine with AMSOIL?
Questions? Call or text 1-417-649-6776 — Walter & Regina are happy to help.
Related Posts

Buying or selling a home in the Four States area? Walter Hayes, Oak Creek Realty Group, licensed in Missouri. Visit walterhayes.com
